By sledusa on Wednesday, October 28, 2009 - 11:21 pm: Edit Post
The tach doesn't work.
The code seems to be the servo motor
that runs the power valves.
I tried a different tach. No luck.
Any ideas. HELP
The engine light blinks 7 times and just keeps doing it.
It seems to run fine.
By ezra on Thursday, October 29, 2009 - 12:24 am: Edit Post
did you clean pv? watch to see if the survo motor works?
By nytro_rtx on Thursday, October 29, 2009 - 09:46 am: Edit Post
I had some wires rub thru where they are routed behind the steering post right above the gas tank. Also they rubbed thru the wiring harness under the motor, I never had this problem tho. My tach would also stop working. I just taped everything up & have never had a problem since.
nytro
By sledusa on Sunday, November 01, 2009 - 10:37 am: Edit Post
ttt
By maxwell on Monday, November 02, 2009 - 08:22 am: Edit Post
that code is stating that the servo motor is non-operational or disconnected.
Is this a new sled to you, or did this code just appear?
By sledusa on Tuesday, November 03, 2009 - 01:02 am: Edit Post
I rode it last year but can't remember if it did it.
By maxwell on Tuesday, November 03, 2009 - 08:34 am: Edit Post
HMM,
I am betting it is an issue with a wire rub through on the frame.
You will need to pull out the wiring harness from underneath the motor. Unhook the harness from the front of the sled, and tape a small diameter rope to it. Pull the harness out from the rear of the sled and look for rub through area. Fix those areas, and use the rope to fish the wire harness back through the underside of the engine (or route the harness over the top side of the engine).
I sent you an email
