Page 6 of 7 FirstFirst ... 4567 LastLast
Results 126 to 150 of 172
  1. #126
    Join Date
    Dec 2009
    Location
    Greenland, Mi
    Posts
    4,153

    Default

    Quote Originally Posted by favoritos View Post
    Front steps are already perfect. Just think of all the time you could save on shoveling snow.

    You must have a few trips up and down ladders by now. Did you do those 3rd floor windows from the ladder?
    No, all the window sash's come out of the frame and worked on on the bench. Just getting the sash's out can be a job by itself especially when they have not moved in 35 years and have been painted shut. To get them out you have to remove the outer sash stop and that will allow the lower window to be removed but than the hard part. You need to get the upper sash down to the bottom and remove it's stop which is a bear. Some of the cords break, most of the stops are painted in and need to be loosened up without damaging them. Next I use the multi tool and scrape the windows and than by hand, remove broken glass, sand the windows, install new glass, re-glaze, prime, finish paint, scrape paint off glass. Do the same thing to the stops, and just clean up the slide jambs. All that than you still have the window frame inside and out to do along with trim on both sides. It really is major time consuming. I made an early day today as I am overly frustrated with the slow drying of glazing and paint with this rain and cool temps. I just said screw it, it's one of those days!
    Last edited by lenny; 09-21-2011 at 03:00 PM.

  2. #127
    Join Date
    Dec 2009
    Location
    North Twin Cities
    Posts
    889

    Default

    Lenny, I think a lot of people would have said "screw it" a long time ago.

    That is a lot of work just on the windows. How the heck do you replace the broken cords without opening the wall?

  3. #128
    Join Date
    Dec 2009
    Location
    Greenland, Mi
    Posts
    4,153

    Default

    Quote Originally Posted by favoritos View Post
    Lenny, I think a lot of people would have said "screw it" a long time ago.

    That is a lot of work just on the windows. How the heck do you replace the broken cords without opening the wall?
    The window frames have a small panel (3"x12") that is removable which allows access to the weights, getting the cord down to the weights is another story. Easiest way is to remove casing on one side and cut a small chunk out of plaster that will cover back up when casing is reinstalled. Removing the small piece of plaster allows you to grab the cord as you slip it through the top pulley and tie a small weight to it in order to get the cord down to the bottom removable panel to re-tie the new cord to the weight, easy as pie,,,yea right!

  4. #129
    Join Date
    Dec 2009
    Location
    Greenland, Mi
    Posts
    4,153

    Default

    1st floor windows are complete, attic windows need paint scraped off glass and installed. Basement windows are out and ready to prime. I can see the light at the end of the tunnel as far as windows goes.

    Stats: 72 window sash's, 35 doors, 82 steps on all stairs, 428 individual pcs of glass within all doors and windows including storms (crazy)
    Last edited by lenny; 09-22-2011 at 11:41 PM.

  5. #130
    Join Date
    Dec 2009
    Location
    Greenland, Mi
    Posts
    4,153

    Default

    in the beginning I couldn't cut a piece of glass to save my life, now I am a glass cutting fool. When I removed all the broken wavy glass I saved anything of size and have been using it to replace smaller pieces. Today I cut my last few pcs and glazed them. Tomorrow I install the basement windows and she's all done. Another milestone complete and ready for the next project (front steps.)

    Till than, Leo the Lop (as my buddy calls me, not sure what that means)

  6. #131
    Join Date
    Dec 2009
    Location
    spring grove il.
    Posts
    136

    Default

    Lenny i feel ypur pain brother, just finished that side job scrapeing and painting 45 windows on a 100yr. old house. It took for ever.

  7. #132
    Join Date
    Dec 2009
    Location
    Lansing, Mi.
    Posts
    546

    Default

    Quote Originally Posted by lenny View Post
    This is house number 6 and my wife says it's the last one so it better be good this time.
    Sorry lenny, but every time I bring up this thread this line always catches my eye. Is your wife trying to say that the other 5 were not so good?

  8. #133
    Join Date
    Dec 2009
    Location
    Greenland, Mi
    Posts
    4,153

    Default

    Quote Originally Posted by 700classic View Post
    Sorry lenny, but every time I bring up this thread this line always catches my eye. Is your wife trying to say that the other 5 were not so good?
    now you got me wondering, where's that women at!

  9. #134
    Join Date
    Dec 2009
    Location
    Greenland, Mi
    Posts
    4,153

    Default

    just got back from da old place, was working on the front door, big old 42" door. The front entrance had a temp built by previous owner to keep people out. The door had been kicked in so one of the panels was split and damaged. The style' were separating from the rails about 1/4". I set the door on a bench and took a good look at it. I borrowed some huge clamps from my buddy and before clamping I glued the joints up real good and tightened er up. All the joints came right back to place. There was a big split in one of the panels where it had been kicked in. When the door was kicked the panel split and hung up on itself and warped in that condition for the last 20 years probably. What I did was tap the rail apart further and allow some room to separate the broken split panel. AS had to smack it hard and she snapped close but being warped it wasn't flush. I was able to get the pcs flush and clamped the door tight and she stayed. Very much amazed now that the door looks really good. Pre drilled and counter sunk some 3" screws to keep it tight. Tomorrow I'll replace the damaged jam and trim, if this comes out nice I'll be so pleased.
    Attached Images Attached Images

  10. #135
    Join Date
    Dec 2009
    Location
    Oscoda MI
    Posts
    35

    Default

    WOW!!!! Awesome thread and work!!!! I need to find a place like that around here for my ever growing family, I thought the 4 bedroom i built 7 years ago was going to be enough......
    Nice work.....

    We have been looking for an old farm house with a little property but there is not much of that left?

  11. #136
    Join Date
    Dec 2009
    Location
    Greenland, Mi
    Posts
    4,153

    Default

    Thanks Duane! Today I got the front door into shape and this old gale of a house has gotten her dignity back. Had enough time to take the back door off and re-work it. She needed some serious planning and replacing broken glass. Both doors swing nice now, latch perfectly. I just need a few skeleton keys so I can look them
    Attached Images Attached Images

  12. #137

    Default

    Unless I missed it Didn't see any mention, How you gunna heat it?

  13. #138
    Join Date
    Dec 2009
    Location
    Greenland, Mi
    Posts
    4,153

    Default

    My latest plan is running hot water under the floors with reflectors. If I plan right and save I would love to go with a Duel fuel boiler, LP and wood with the wood heat a gasificatioin system and I would run the wood as the primary, probably along with a huge holding tank. 10 g's would cover it and pay for itself in 5 years. Tarm USA or ECO have 94% efficient gasification technology and for wood that is remarkable. I really like the idea of allowing the wood to season for a year and being outside a winter killing most bugs so I can store wood in da basement.

  14. #139
    Join Date
    Dec 2009
    Location
    Greenland, Mi
    Posts
    4,153

    Default

    Today I dug up by hand the old footings for the front porch stairs. Those footing went down 22" only, no wonder they were crooked and heaved. I dug down 46" and set my posts, poured some crete. Installed a new lock on the front door, installed all the basement windows. The house is ready for the winter now and all closed up. Tomorrow I finish the front stairs and start trim on the porch.

    If anyone wants to come up real soon and help me gut the place I will give them free lodging this winter and they can also stay for free while they are here. We can also have a few cookouts and a few brew's. Fall colors are getting close to peak and maybe a little atving will be in order,,, anyone?

  15. #140
    Join Date
    Dec 2009
    Location
    Belvidere IL
    Posts
    394

    Default

    Lenny this is absolutely amazing. You are a true inspiration to us all. There is nothing like old school character and charm!

  16. #141
    Join Date
    Dec 2009
    Location
    Greenland, Mi
    Posts
    4,153

    Default

    tanks, you da cat women

  17. #142
    Join Date
    Dec 2009
    Location
    Greenland, Mi
    Posts
    4,153

    Default

    I've been doing a few actual paying jobs and have 2 large jobs coming soon so things are progressing slow now. I do have steps now in front but still need to trim the porch and will be there for the next 4 days so pics soon.

  18. #143
    Join Date
    Dec 2009
    Location
    Greenland, Mi
    Posts
    4,153

    Default

    started working on the old place again. Finally finished the porch, will have pics tomorrow, left at dark tonight

  19. #144
    Join Date
    Dec 2009
    Location
    Greenland, Mi
    Posts
    4,153

    Default

    finally have a few updated pictures
    Attached Images Attached Images

  20. #145
    Join Date
    Dec 2009
    Location
    McHenry, Il / Gogebic West Shore
    Posts
    579

    Default

    Very nice Lenny.

  21. #146
    Join Date
    Dec 2009
    Location
    Oak Park IL/White Pine MI
    Posts
    1,316

    Default

    Porch looks nice, lenny! Not much time left for outside work...

  22. #147
    Join Date
    Dec 2009
    Location
    Greenland, Mi
    Posts
    4,153

    Default

    I hope we get another week with sun and in the 50's or even 60's, we'll see!

  23. #148
    Join Date
    Dec 2009
    Location
    Stewartville, MN
    Posts
    395

    Default

    I have to say, everything you have done so far looks really nice. The front porch work is great!

    I love these remodel threads you have done, keep up the good work!

  24. #149
    Join Date
    Dec 2009
    Location
    Greenland, Mi
    Posts
    4,153

    Default

    thanks everybody! The rain and wind up here has been strong. It's kinda hard to plan outdoor work when the weather is like it is. I have a roof job to do and have had the material for a week now and can't start it. Looks like fri may be looking up. My wife has me fixin stuff around the house. Also a pellet stove in "The old Town Hall" is down and I have parts on the way, circuit board blew.

  25. #150
    Join Date
    Feb 2010
    Location
    Western U.P. Paulding
    Posts
    1,815

    Default

    Looking good Lenny! Oh and by the way guess what I'm having for breakfast.....GEN HOE! just sayin'

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

» Adsense

» June 2013

S M T W T F S
26 27 28 29 30 31 1
2 3 4 5 6 7 8
9 10 11 12 13 14 15
16 17 18 19 20 21 22
23 24 25 26 27 28 29
30 1 2 3 4 5 6

» Stats

Members: 17,414
Threads: 23,329
Posts: 238,755

» Online Users: 42

3 members and 39 guests
Most users ever online was 533, 01-23-2012 at 02:10 PM.

» Today's Birthdays

None
Powered by vBadvanced CMPS v4.1.2